Fluidizer (Vulcanizing Unit) DN500-2500

Lanhao Environmental Fluidizer (Fluidization Device) Technical Parameters (DN500-2500)
I. Core Specifications
Parameter Value Remarks
Diameter Range DN500-DN2500 Compatible with large blow tanks and pulverized coal bins
Design Pressure 0.6-1.6MPa Complies with PN1.6 standard

Operating Temperature ≤100℃ Withstands instantaneous high temperature of 150℃

Connection Method Large flange/welding Supports integrated and split installation
II. Structural Features
Sintered stainless steel mesh
Made of 1Cr18Ni9Ti stainless steel wire mesh, wear resistance is 3 times higher than ordinary filter mesh.
Dual-mode fluidization
Supports top discharge (SLH type) and bottom discharge (XLH type), eliminating powder accumulation in the cone section.

Energy-saving design
Air consumption reduced by 40%, optimized airflow distribution through the 860mm outer diameter of the gasification plate.
III. Application Scenarios
Blast furnace injection system: Used in the cone section of pulverized coal bins to ensure stable coal powder conveying.
Pneumatic conveying: Compatible with 0.3-0.5MPa compressed air, flow loss ≤5%.

IV. Installation Requirements
Level calibration
The angle between the fluidizer axis and the horizontal plane must be ≤3° to avoid local powder accumulation.
Pressure monitoring
It is recommended to install differential pressure gauges (range 0-0.1MPa) at the inlet and outlet.